Automated Gate Systems Technician case studies
Automated Gate Systems Technician · Put your knowledge to work in context.
The Automated Gate Systems Technician credential is an independent certification for technicians who install, service, and maintain powered gate operators on residential, commercial, and industrial sites. It is aimed at people already working in the gate and access-control trades, as well as apprentices preparing to move into field service. The Automated Gate Systems Technician case studies are 5 cases and about 3,001 words.
1Residential Slide Gate on a Slope with a Missing Photoeye Pair
You are commissioning a 12 ft (3.7 m) cantilever slide gate on a residential driveway that slopes 4% along the travel path. The operator is a 1/2 HP electromechanical unit rated for a 16 ft gate and 1,200 lb.
662 words, about 3 min2Commercial Swing Gate Sharing a Lane with a Card Reader and Loop Detector
A 16 ft (4.9 m) dual-leaf swing gate serves a commercial parking lane. Vehicles approach a pedestal card reader; an in-ground exit loop is located 6 ft past the gate on the secure side.
647 words, about 3 min3Undersized Operator on a Wind-Loaded Commercial Cantilever Gate
A 24 ft (7.3 m) cantilever slide gate with a steel frame and mesh infill is installed at a coastal commercial site. Nameplate gate weight is 1,050 lb.
579 words, about 3 min4Battery Backup Operator Fails After Power Outage at a Medical Clinic
A 10 ft (3 m) barrier arm operator controls a single-lane entrance at a medical clinic. The operator has a battery backup intended to allow egress and one open/close cycle during outages.
574 words, about 3 min5Photoeye Alignment Kept Failing at a Sunny Loading Dock
A loading dock slide gate uses a through-beam photoeye pair mounted 20 in (508 mm) above grade across a 12 ft opening. The receiver faces west and receives direct afternoon sun.
539 words, about 3 min