VCE Art Making and Exhibiting case studies
VCE Art Making and Exhibiting · Put your knowledge to work in context.
VCE Art Making and Exhibiting is a Victorian senior secondary study, assessed by the Victorian Curriculum and Assessment Authority (VCAA), the body whose website hosts curriculum, assessment and examination material for VCE studies. This page is an independent study resource: it is not affiliated with, endorsed by, or operated by VCAA, and it does not reproduce any official examination paper or commercial question bank. The VCE Art Making and Exhibiting case studies are 5 cases and about 2,494 words.
1The Overloaded Portfolio Wall
A Year 12 student has completed a body of six resolved works for the end-of-year exhibition. The gallery has three wall bays: Bay A is 3.2 m wide with a 2.4 m ceiling and a fixed hanging rail; Bay B is 2.1 m wide under a sloping ceiling that drops from 2.6 m to 1.9 m; Bay C is a freestanding partition 2.4 m wide with two visible faces.
585 words, about 3 min2When the Glaze Test Lies
A student is making a series of five ceramic vessels for assessment. They tested a new commercial glaze on three small tiles fired to cone 6 and recorded a glossy teal result with no defects.
491 words, about 2 min3Reading a Work You Cannot Name
A student is asked to analyse an unfamiliar contemporary painting in an exam. The work shows a large, roughly 2 m by 3 m canvas dominated by horizontal bands of ochre, grey, and a single narrow band of cadmium red near the lower edge.
478 words, about 2 min4The Poster That Fails Its Brief
A student designs an A2 poster for a community music festival. The brief specifies: the event name must be legible from 5 m, the date and venue must be readable at 1 m, the design must work for both print and a social media square crop, and it must use the festival's two brand colours (a deep navy and a warm yellow).
492 words, about 2 min5The Shared Studio Deadline
Three students share a studio and a single drying rack with 12 shelves. Each student needs to complete a multi-part work involving wet plaster over armature, which must dry undisturbed for 48 hours before any further work.
448 words, about 2 min