Maharashtra HSC Physics study materials
Maharashtra HSC Physics study resources

Maharashtra HSC Physics case studies

Maharashtra HSC Physics · Put your knowledge to work in context.

The Maharashtra HSC Physics paper is the Class 12 Physics examination set by the Maharashtra State Board of Secondary and Higher Secondary Education (MSBSHSE). It is taken by students completing the science stream at higher secondary level, and its marks are used for board certification and for admission to undergraduate science, engineering, and medical courses, alongside entrance examinations. The Maharashtra HSC Physics case studies are 5 cases and about 2,737 words.

1

Two Rollers on the Same Incline: Shape Factor Beats Mass

In a practical revision session for Maharashtra HSC Physics, a teacher gives two rollers that look identical from outside. Roller A is a solid cylinder and roller B is a thin-walled hollow cylinder; both have mass 2.0 kg and outer radius 5.0 cm.

620 words, about 3 min
2

Stokes' Law in a Narrow Cylinder: The Wall Correction

During the viscosity practical, a student drops small steel balls of radius 2.0 mm and density 7.8 × 10³ kg m⁻³ into a measuring cylinder of castor oil of density 0.96 × 10³ kg m⁻³. The handbook value of the oil's viscosity at room temperature is 0.99 Pa s.

599 words, about 3 min
3

Young's Double Slit with a Film and Then Under Water

In a wave-optics experiment a student uses a sodium lamp of wavelength 589 nm, slits 0.40 mm apart, and a screen 1.50 m away. The measured fringe width is 2.2 mm.

444 words, about 2 min
4

Power-Factor Correction in a Series LCR Circuit

In an AC laboratory a student connects a coil of resistance 20 Ω and inductance 0.10 H in series with a 50 μF capacitor across a 230 V, 50 Hz supply. He is asked to improve the power factor of this series circuit to unity.

485 words, about 2 min
5

A Zener Regulator That Regulates Only Some of the Time

A student builds a simple regulated supply: a 10 V unregulated DC input feeds a 100 Ω series resistor and a 6.0 V zener diode connected in parallel with the load. With a 200 Ω load the output is a steady 6.0 V.

589 words, about 3 min