Punjab PSEB Matric NSQF Electronics study guide
Punjab PSEB Matric NSQF Electronics · Work through your exam, one topic at a time.
The Punjab School Education Board (PSEB) Matriculation (Class 10) NSQF examination is the board-level assessment route for Class 10 candidates in Punjab who take National Skills Qualification Framework vocational subjects alongside their general subjects. This page covers the Electronics trade. PSEB came into existence through a legislative enactment in November 1969, and in 1987 the Vidhan Sabha amended the Board's Act to grant it autonomy; the Board sits at Vidya Bhawan, Phase-8, SAS Nagar (Mohali). For NSQF candidates the board publishes session-specific instructions, a vocational syllabus, and a separate practical-examiner letter - for the July 2026 session these were "Instructions for NSQF Exams July 2026", the "Vocational Group Syllabus 2026-27" (dated 06-04-2026), and the "Letter for External Examiner for Practical paper July 2026". Topics on this exam: NSQF vocational trade theory (Electronics) and NSQF vocational practical (Electronics). The Punjab PSEB Matric NSQF Electronics study guide has 2 sections and about 718 words.
01NSQF Vocational Trade Theory (Electronics)
The NSQF Vocational Trade Theory (Electronics) domain checks whether you can explain, not just recognise, the trade. Expect questions on electrical quantities and units, component symbols and colour codes, Ohm’s law, series and parallel networks, AC/DC differences, semiconductors, rectifiers, transistors, digital gates, power supplies, and safe measurement practice. PSEB matric NSQF papers often link each fact to a shop-floor task, so learn the reason behind a rule. Current is measured in amperes (A), voltage in volts (V), resistance in ohms (Ω); 1 kΩ = 1000 Ω and 1 mA = 0.001 A.
351 words, about 2 min02NSQF Vocational Practical (Electronics)
The NSQF Vocational Practical (Electronics) domain assesses safe bench work: selecting tools, stripping and tinning wire, soldering and desoldering, reading component values, using a digital multimeter (DMM), breadboarding, PCB handling, and locating simple faults. The examiner looks for correct procedure as much as a working circuit, so state what you are doing and why. Isolate power before touching a circuit; discharge filter capacitors with a resistor, not a screwdriver. Use an ESD wrist strap or touch a grounded metal point before handling CMOS ICs and MOSFETs.
367 words, about 2 min