PEC EPE Mechatronics study guide
PEC EPE Mechatronics · Work through your exam, one topic at a time.
The Engineering Practice Examination (EPE) is the Pakistan Engineering Council's practice-oriented examination, listed on the PEC website under its Continuing Professional Development (CPD) section alongside the EPE Guidebook, a grievance-redressal policy for EPE candidates, and published session results. This page covers the Mechatronics Engineering stream, one of the discipline curricula PEC publishes (the Mechatronics Engineering curriculum appears in the PEC Curricula-2024 set). The PEC EPE Mechatronics study guide has 8 sections and about 2,116 words.
01Engineering Mathematics and Basic Sciences
This domain tests the mathematical and physical toolkit behind mechatronic models: linear algebra, calculus, differential equations, complex numbers, probability, and basic mechanics and electricity. Expect questions that require choosing a model, applying a rule, and interpreting units rather than memorising long derivations.
270 words, about 1 min02Electrical, Electronic and Embedded Systems
Electrical, electronic and embedded systems questions bridge circuit analysis to microcontroller behaviour. The exam tests whether you can simplify a circuit, check an op-amp or transistor state, and reason about digital timing, conversion and communication rather than just quote component values.
294 words, about 1 min03Mechanical Systems
This domain tests statics, dynamics, stress analysis, torsion, beam deflection, friction, vibration and basic thermal and fluid effects. Questions usually combine a free-body diagram with a formula and demand correct SI units and boundary conditions.
250 words, about 1 min04Machine Elements and Design
Machine elements and design questions test selection and sizing of gears, bearings, shafts, belts, fasteners, springs and fits, plus failure theories and design factors. The emphasis is on load paths, ratings and units rather than catalogue recall.
293 words, about 1 min05Control Systems
Control systems questions test transfer functions, block-diagram reduction, stability, transient response, steady-state error, PID tuning, root locus and frequency response. You should be able to move between time-domain specifications and s-domain parameters.
245 words, about 1 min06Instrumentation and Measurement
Instrumentation and measurement tests sensor selection, bridge and signal-conditioning circuits, uncertainty, calibration, resolution, sampling and noise. The exam expects defensible measurement statements: value, unit, uncertainty and conditions.
240 words, about 1 min07Robotics
Robotics questions cover coordinate frames, forward and inverse kinematics, Jacobians, singularities, actuators, sensors, dynamics and path planning. The exam tests geometric reasoning and the ability to distinguish a robot configuration from its workspace.
257 words, about 1 min08Automation, Manufacturing and Professional Practice
Automation, manufacturing and professional practice tests PLC operation, sensors and actuators, production metrics, CNC and manufacturing tolerances, safety, standards and engineering ethics. Questions often use a plant scenario and ask for the best engineering judgement, not just a formula.
267 words, about 1 min