Cert III Motorcycle Mech case studies
Cert III Motorcycle Mech · Put your knowledge to work in context.
The AUR30820 Certificate III in Motorcycle Mechanical Technology is an Australian vocational qualification reflecting the role of individuals who perform a broad range of tasks on a variety of motorcycles in the automotive service and repair industry. It suits people working in, or preparing to work in, motorcycle service and repair workshops who need trade-level diagnostic and repair skills rather than routine servicing alone. The Cert III Motorcycle Mech case studies are 5 cases and about 2,626 words.
1Intermittent No-Start After a Wet Commute
A 2016 650 cc parallel-twin commuter arrives after three no-start complaints in two weeks. Each time the owner reports the engine cranking briskly but not firing, and each time it restarted after sitting overnight in a dry garage.
603 words, about 3 min2Brake Judder Complaint After Pad Replacement
A 250 cc learner-approved bike comes back two days after a front pad replacement with a complaint of lever pulsing and judder under firm braking. The technician who did the job is off sick.
533 words, about 3 min3Diagnosing a Charging Fault on a Customer's Touring Bike
A touring bike with 62,000 km arrives with a flat battery after a long ride. The owner fitted a new battery 500 km ago and a phone charger and heated grips at the same time.
518 words, about 3 min4Torque and Thread Repair on an Alloy Engine Case
An apprentice is fitting a clutch cover on a 400 cc single. The manual specifies 10 Nm for the cover bolts into the alloy case.
495 words, about 2 min5Road Test Judgement on a Modified Bike
A customer brings in a bike with an aftermarket exhaust, a piggyback fuel controller, and a pod filter fitted elsewhere. It runs roughly at small throttle openings and stalls occasionally at idle.
477 words, about 2 min