ACP Inventor case studies
ACP Inventor · Put your knowledge to work in context.
The Autodesk Certified Professional (ACP) credential is one of four Autodesk certification levels, positioned above Certified User and Certified Associate and below Certified Expert. Autodesk describes the Professional tier as intended for candidates with advanced skills who can solve complex challenges, helping them stand out in a competitive job market. The ACP Inventor case studies are 5 cases and about 3,513 words.
1Hollow Bracket Wall Thickness After Shell
A designer models a cast-aluminum mounting bracket as a solid extrusion 180 mm long, 90 mm wide and 45 mm deep, then applies the Shell command with a uniform thickness of 4 mm and selects the two 90 x 45 mm end faces as removed faces. The part mass, checked in iProperties, is 18 percent higher than the target of 1.35 kg.
679 words, about 3 min2Assembly Constraint Conflict in a Linkage Subassembly
A packaging machine assembly contains a four-bar linkage subassembly with a crank, coupler, rocker and ground link. Each part is modeled at its own origin.
660 words, about 3 min3Drawing View Loses Dimensions After Model Change
A detail drawing of a machined shaft carries 34 dimensions placed with the Retrieve Dimensions and general dimension tools, plus a section view and a detail view. The shaft model is revised: a keyway is widened from 8 mm to 10 mm and moved 12 mm along the axis, and a shoulder fillet is increased.
684 words, about 3 min4Sheet Metal Bend Relief and Flat Pattern Failure
A 1.5 mm mild steel enclosure has four bends: two 90-degree flanges along the long edges and two 90-degree flanges on the short edges, meeting at the corners. The sheet metal style uses a K-factor of 0.44 and a bend radius of 1.5 mm.
764 words, about 4 min5Loft With Guide Rails Produces Twisted Surface
A duct transition is modeled as a loft between a 300 x 200 mm rectangular section and a 150 mm diameter circular section, 400 mm apart. The designer adds two guide rails - one along the top of the duct and one along the bottom - to control the transition shape.
726 words, about 4 min