BC Class 2 Bus study guide
BC Class 2 Bus · Work through your exam, one topic at a time.
Note: this is an independent study resource. It is not produced, endorsed by, or affiliated with the Insurance Corporation of British Columbia (ICBC), and it is not an official test. The BC Class 2 Bus study guide has 5 sections and about 1,859 words.
01Pre-trip inspection: a hands-on, systematic walk-around
A pre-trip inspection is a hands-on safety check, not paperwork. In British Columbia a driver must inspect the bus before each trip day and record the result, and a Class 2 candidate is graded on doing the walk-around properly and explaining what is seen.
314 words, about 2 min02Vehicle condition and air brake system checks
Air brakes are the highest-risk system on a Class 2 bus, so the exam expects a sequence, not isolated facts. With the engine running at fast idle, pressure should climb from about 85 psi (587 kPa) to 100 psi (690 kPa) within two minutes.
321 words, about 2 min03Safe and defensive driving of buses and large commercial vehicles
A loaded bus weighs many times a car and needs far more distance to stop, so defensive driving in Class 2 is mostly about buying time and space. Aim for a following distance of at least four seconds in good conditions, and double it or more in rain, snow, or darkness.
303 words, about 2 min04Passenger safety, boarding, seating, and load security
Safe passage of riders begins before the doors open. Approach and stop smoothly at the marked zone, set the parking brake, select neutral or park as required, and secure the bus before releasing passengers.
299 words, about 1 min05Emergency procedures, incidents, and collision response
Emergency response follows a fixed order: stop safely, secure the vehicle, protect and warn, then care for people. If a fire starts, stop immediately, shut off the engine, set the parking brake, evacuate away from traffic and upwind, and only then attempt to fight a small fire with the extinguisher while someone calls 911.
622 words, about 3 min