Consulting Engineer case studies

Consulting Engineer · Put your knowledge to work in context.

The Consulting Engineer credential is a professional certification intended for engineers who advise clients, lead multidisciplinary projects, and take professional responsibility for recommendations rather than only for designs. Candidates typically work as independent consultants, senior engineers in advisory firms, or technical leads who interface directly with owners, regulators, and contractors. The Consulting Engineer case studies are 5 cases and about 4,717 words.

Membrane Plant Upgrade: Reading the Earned Value Signal at Month 9

Northgate Water Authority has engaged your firm as program manager for a 48 million membrane filtration upgrade at its Riverside plant. At the month-9 steering committee, the earned value data are: BAC 48.0M, PV 27.0M, EV 23.5M, AC 25.3M.

1,044 words, about 5 min 2

Distribution Centre Fee Erosion and a Cold-Store Change Order

Halden MEP Consulting holds a lump-sum fixed fee of 1,350,000 for full mechanical, electrical and plumbing design of a 42,000 m2 distribution centre, with a nine-month programme and a 10% holdback released at practical completion. The proposal was built on 9,000 hours at a blended charge rate of 150/hour; the firm's direct cost rate is 95/hour, inclusive of overhead absorption.

727 words, about 4 min 3

Low Cylinder Strengths in Post-Tensioned Slabs: What the Engineer of Record Directs

A five-storey reinforced concrete office building uses post-tensioned slabs on an 8.4 m grid, and the specified characteristic cylinder strength is 35 MPa at 28 days. Of 40 standard-cured cylinders from the last 12 pours, seven fell below 35 MPa; the lowest, from pour P-14 at level 2 grid C-F, is 26.8 MPa.

1,083 words, about 5 min 4

Pre-Submission Access and a Request to Bury a Geotechnical Hazard

Your firm is shortlisted for the design of a $220 million light-rail interchange for a metropolitan transit authority. Technical proposals are scored by a five-member panel that includes the authority's chief structures engineer, a former partner of your firm who still holds a 4% equity interest in it - a fact in the annual returns but not in the panel's conflict register.

773 words, about 4 min 5

Guarding, Anchors and a Risk Register That Is Not Controlling Anything

During a design-phase HAZOP for a 60,000 t grain terminal, your team finds that the maintenance walkway to the head of the 42 m conveyor has no compliant fall protection on its outboard side, and that clearing a typical blockage requires a worker to stand within 300 mm of an unguarded return idler. The client's project manager argues these are 'construction-phase safety' items and asks that they move to the contractor's risk register to protect the 310 million capital estimate; deleting them saves an estimated 480,000.

1,090 words, about 5 min