CSCS 360° Excavator case studies
CSCS 360° Excavator · Put your knowledge to work in context.
The CSCS 360° Excavator card is a competence credential for operators of tracked or wheeled 360-degree excavators, covering machines both above and below 10 tonnes. It is aimed at plant operators who need to demonstrate to employers and site managers that they can run this equipment safely and productively, and it is typically required before being allowed to operate on a construction site. The CSCS 360° Excavator case studies are 5 cases and about 2,943 words.
1Tracking a 360° Along a Cambered Haul Road
You are operating a 22-tonne tracked 360° excavator with a 2.9 m dipper and a 1.2 m³ bucket, moving from a stockpile to a new cut 400 m away along a compacted site haul road. The road runs along a clay embankment with a 1-in-8 cross-fall toward an open drainage channel on the left.
533 words, about 3 min2Excavating Beside a Marked HV Cable
You are digging a 1.2 m deep drainage trench with a 360° excavator and a 600 mm trenching bucket. The site drawings and a CAT scan show an 11 kV cable running parallel to the trench line, with the marked centreline 1.5 m from the trench edge.
610 words, about 3 min3Lifting a Manhole Ring with the Bucket
You need to place a 600 kg precast concrete manhole ring into a 1.5 m deep excavation. The site has no dedicated lifting attachment, but the excavator has a lifting eye on the bucket and a certified chain sling in the site store.
589 words, about 3 min4Pre-Start Checks After a Night Shift
You are the first operator on shift on a 360° excavator that was used until 22:00 the previous night. The machine is parked on level hardstanding.
576 words, about 3 min5Refuelling and Parking on a Sloping Site at End of Shift
It is the end of a 10-hour shift. Your 360° excavator is low on fuel and parked on a 1-in-10 slope on a compacted site compound, with the bucket grounded and the dozer blade down.
635 words, about 3 min