Scaffolding Works NC II study guide
Scaffolding Works NC II · Work through your exam, one topic at a time.
Scaffolding Works NC II is a Philippine TVET qualification under the Technical Education and Skills Development Authority (TESDA) framework, awarded to workers who can erect, inspect, alter, and dismantle tubular and modular scaffolding safely to industry standards. It suits scaffolders, riggers, construction helpers moving into access work, and site supervisors who need to verify that scaffolds are built and tagged correctly. The Scaffolding Works NC II study guide has 7 sections and about 2,594 words.
01Occupational Health and Safety and Housekeeping
OHS and housekeeping questions test whether you can set up, work on and leave a scaffold site without endangering yourself, your mates or the public. In the Philippines the frame is RA 11058 and its IRR (DO 198-18) plus the construction safety guidelines in DO 13, s.
361 words, about 2 min02Tools, Equipment, and Materials Handling and Maintenance
You must know the components of tube-and-coupler and frame scaffolds, how to handle them without damage or injury, and how to inspect, maintain and store them so they stay serviceable. Tube : 48.3 mm outside diameter, 3.2 or 4.0 mm wall, in 2.4 m, 3.0 m and 6.0 m lengths.
360 words, about 2 min03Interpretation of Drawings and Scaffold Planning
These questions test whether you can read the scaffold layout plan and elevation, the structural drawings, the tie plan and the site plan, then turn them into a buildable, safe plan. Read the title block first: drawing number, revision, scale and date.
361 words, about 2 min04Scaffold Erection and Installation
Erection and installation is the practical heart of the trade: setting out, building plumb and level, tying to the structure, and providing platforms, guardrails and access that can be used safely. Sequence : set out and level the ground, place soleplates and base plates, erect the first standards, level and plumb them, then add ledgers and transoms lift by lift.
385 words, about 2 min05Scaffold Inspection, Dismantling, and Storage
You must inspect a scaffold formally, decide whether it is safe for use, dismantle it without dropping anything, and store components so they remain serviceable. Inspect before first use, at the start of every shift, after any alteration, after high wind, rain or impact, and at documented intervals of at least weekly .
379 words, about 2 min06Communication and Documentation
These questions test whether the right information reaches the right people at the right time, and whether the paper trail would survive an audit or an incident investigation. Before work : job hazard analysis, permit to work where required, a documented toolbox talk with signatures, and confirmation that everyone holds the current drawing revision.
336 words, about 2 min07Basic Numeracy and Measurement
Numeracy and measurement questions check that you can take off quantities from a drawing, count materials correctly, check loads against the duty class, and measure plumb, level and square with real instruments. Work in consistent units: 1 m = 1,000 mm; 1 kN ≈ 102 kg, so 1 t ≈ 9.8 kN.
412 words, about 2 min