GA Plumber case studies
GA Plumber · Put your knowledge to work in context.
The Georgia plumber license is the state credential that allows a tradesperson to perform plumbing work for pay in Georgia, and it is issued through the state's professional licensing board structure rather than by any city or county. Two levels are commonly referenced: a journeyman credential for plumbers working under supervision, and a master credential for those who intend to contract, pull permits, or supervise others. The GA Plumber case studies are 5 cases and about 3,670 words.
1Relief Valve Drip After a PRV Retrofit - Water Heaters, Temperature and Pressure Control
A two-story house was converted from a private well to a municipal supply. Static street pressure measured at the curb stop is 118 psi, so the installer added a 3/4-inch pressure-reducing valve at the meter, set it to 50 psi, and the meter yoke carries a check valve.
755 words, about 4 min2Basement Bath Branch Without Enough Fall - Slope and Drainage Sizing
A finished basement bath group is being added to a 1960s split-level. The new 3-inch PVC branch runs 26 feet from the water closet to a 3-by-4 wye cut into the existing 4-inch cast-iron building drain.
691 words, about 3 min3Island Sink Twelve Feet From the Stack - Venting Systems and Vent Sizing
A kitchen remodel places the sink on a new island in the middle of a slab-on-grade floor, 12 feet from the nearest 2-inch vent stack. That stack already serves a bathroom group and is close to its fixture-unit capacity.
744 words, about 4 min4Mixed-Hazard Commercial Service - Backflow Prevention and Cross-Connection Control
A 2-inch domestic service and a 4-inch fire line enter a 12,000-square-foot commercial building. On the domestic side: an irrigation system with pop-up heads fed from a 55-gallon fertilizer injection tank, a carbonated beverage dispenser in the break room, and a boiler with a glycol feed tank.
746 words, about 4 min5Air Test on Plastic DWV the Night Before Inspection - Tools, Testing and Jobsite Practices
A three-story addition's DWV rough-in in 2- and 4-inch PVC is complete. To avoid the cost of filling the system with water, the foreman plans to air-test at 5 psi for 15 minutes using a 0-60 psi gauge with 2 psi graduations.
734 words, about 4 min