HK Crane Operator (CIC) study guide
HK Crane Operator (CIC) · Work through your exam, one topic at a time.
The Construction Crane Operators stream sits under the Machineries and Crane Operation group of trade tests run by Hong Kong's Construction Industry Council (CIC). The CIC describes its trade testing role simply: "The CIC provides trade tests for the construction workers." This stream is listed alongside Loadshifting Machinery Operators, Operator of Builder's Lift and Persons Working on Suspended Working Platforms, so it is one of several machine-operator assessments rather than a single general test. It is aimed at construction personnel who operate cranes on site and who want their operating skill assessed against a trade standard through a practical, trade-based test rather than a written academic examination. Because the CIC publishes the crane operator stream as its own page within Trade Tests, candidates should treat that page, its linked test schedule and the Trade Test Application route as the authoritative sources for scheduling, eligibility and results. Preparation should therefore be practical: build real operating hours on the crane types you intend to be assessed on, work under a competent supervisor, and rehearse safe lifting routines - pre-use checks, reading load and radius information, signalling and communication, load control and safe shutdown - until they are habitual. The CIC site also publishes Resources, Downloads and an FAQ section, which are the right places to confirm current arrangements before you apply. Topics on this exam: Construction Crane Operators (Machineries and Crane Operation). The HK Crane Operator (CIC) study guide has 1 section and about 489 words.
01Construction Crane Operators (Machineries and Crane Operation)
This domain covers the machinery and operational side of the CIC crane operator assessment: crane types and configurations, load charts and rated capacity, stability and ground conditions, safety devices, inspection, and communication during lifts on Hong Kong construction sites. Questions often test whether you can apply the manufacturer's capacity data to a real setup rather than recite a single SWL. The rated capacity is the maximum gross load permitted for a specific configuration-boom length, counterweight, outrigger spread, and radius. Radius is the horizontal distance from the slewing centre to the load's centre of gravity, not the boom length.
489 words, about 2 minMore study resources for HK Crane Operator (CIC)
- Practice questions在吊運作業前，吊索具（sling）上標示之安全工作荷重（SWL）已模糊不清，起重機操作員應如何處理？.
- FlashcardsLoad moment. Load weight multiplied by the horizontal radius from the crane's slewing centre to the load's centre of gravity; the load moment limiter compares this value with the crane's rated moment curve.
- Cheat sheetLoad moment = load weight × operating radius measured horizontally from the slewing centre to the load's centre of gravity; capacity charts are valid only for the radius actually measured, not the boom length.
- Key termsSafe Working Load (SWL). The maximum load a crane or lifting accessory is rated to lift safely under stated conditions, marked on the equipment and never exceeded during any lift.
- Study planList the statutory duties of a crane operator, the responsible person (RP) and the competent examiner under Hong Kong's LALGR (Factories and Industrial Undertakings) Regulations and the Cranes and Lifting Appliances safety legislation.
- Common mistakesCandidates memorise one headline capacity figure and treat it as fixed, forgetting that rated capacity falls as radius increases and changes with boom length, counterweight and outrigger setup; the exam deliberately gives a radius that makes the headline figure dangerously wrong.
- Exam-day guideBring the original ID you registered with (typically Hong Kong Identity Card or a passport with valid stay conditions).