CSCS Tower Crane case studies
CSCS Tower Crane · Put your knowledge to work in context.
The CSCS Tower Crane credential is a competency certification for operators of tower cranes on construction sites. It signals that a candidate can configure, inspect, and run a tower crane safely, and that they understand the load chart, the rigging interface, and the signals that keep a lift coordinated. The CSCS Tower Crane case studies are 5 cases and about 2,057 words.
1Wind Gust During a Glass Panel Lift
You are operating a luffing-jib tower crane on a city centre site, lifting a 1.2 t glass curtain-wall panel with a large sail area. The manufacturer's manual states the maximum in-service wind speed is 20 m/s at the jib, and the crane is fitted with an anemometer that logs peak gusts.
470 words, about 2 min2Climbing the Mast Beside a Live Feeder
A hammerhead crane is being climbed from 60 m to 72 m using a hydraulic climbing frame. The mast is 2.0 m square, and the next six standard sections are staged on the deck below.
395 words, about 2 min3Two-Part Line and an Unknown Load
You are asked to lift a bundle of steel reinforcement from a delivery truck to the deck. The bundle is banded but the bands are partly broken, and the site engineer estimates the mass at 'about 2.5 t'.
435 words, about 2 min4Pre-Start Check Finds a Weeping Brake
At the start of the shift you carry out the daily inspection. The crane is a 2019 hammerhead, 55 m jib, with a trolley and a hoist fitted with an electromagnetic brake.
375 words, about 2 min5Slewing Past a Blind Corner with Radio Failure
You are lifting pallets of blockwork from the ground to the third floor of a building under construction. The landing point is behind the building line and is not visible from the cab.
382 words, about 2 min