NCCCO Telehandler case studies

NCCCO Telehandler · Put your knowledge to work in context.

The CCO Telehandler Operator certification is a nationally recognized, internationally accredited credential for operators of rough-terrain forklifts equipped with telescopic booms - machines used to lift, move, and place materials at varying heights and distances. Two specialties are offered: Telehandler – Fixed Cab (THF) and Telehandler – Rotating Cab (THR). The NCCCO Telehandler case studies are 5 cases and about 3,495 words.

Rental Machine Walk-Around: Six Findings and a Superintendent in a Hurry

you are the operator assigned a rented 10,000 lb capacity telehandler with 4,120 hours on it at a commercial remodel. The superintendent needs 3,000 lb of block on the second-floor deck by 8:00.

760 words, about 4 min 2

Soft Fill, a 12% Slope, and a 12.5 kV Line Over the Only Truck Access

You are setting up to unload a 2,300 lb pallet of masonry units from a flatbed at a new single-family lot. The only truck access is a gravel drive on the north side.

680 words, about 3 min 3

Interpolated Chart, Near-Edge Radius, and a Load Center Past 24 Inches

Your 12,000 lb telehandler carries this placarded chart for forks, no attachment, machine level, frame leveling centered: 10 ft - 8,000 lb; 12 ft - 6,500 lb; 14 ft - 5,400 lb; 16 ft - 4,500 lb. The pick is a 4,200 lb steel skid, 8 ft wide and 4 ft deep, sitting on the forks with its back against the fork face.

694 words, about 3 min 4

Traveling 2,600 lb Down a Wet Grade, Across a Crown, and Through a 12-ft Gate

You are moving 2,600 lb of packaged roofing from the street to a lot 300 ft away on a 10,000 lb telehandler. The route drops 6% on greasy gravel, crosses a 4-in crown, then runs along a 10° cross-slope toward a drainage swale before a 90° left turn through a 12-ft gate.

683 words, about 3 min 5

Rooftop Set With a Jib, a 45-Degree Bridle, and Gusts to 24 mph

You are setting a 2,200 lb packaged rooftop unit on a one-story roof, 14 ft above grade. The RTU is 8 ft long, 4 ft wide and 4 ft tall, and the compressor is mounted on one end, so the center of gravity is roughly 8 in off the geometric center.

678 words, about 3 min