MITO Light Auto L4 case studies
MITO Light Auto L4 · Put your knowledge to work in context.
MITO Light Auto L4 (also written MITO Light Automotive Level 4) is a light-vehicle trade-level credential covered on this study page. It sits in the same on-job training model that MITO describes on its site, where MITO supports learning for people working in New Zealand's automotive, commercial road transport, extractives, drilling, gas and logistics industries. The MITO Light Auto L4 case studies are 5 cases and about 2,566 words.
1Intermittent Low Rail Pressure on a Farm-Use Common-Rail Diesel
A 2015 2.2 L common-rail diesel ute used on a farm has 186,000 km and an intermittent P0087. It starts easily cold, but under load at about 2,500 rpm it loses power and enters limp mode; the fault clears after key-off.
550 words, about 3 min2Overnight Parasitic Drain After Towbar and Dash-Cam Fitment
A 2019 petrol SUV has 62,000 km and a 70 Ah battery that went flat after sitting for two days. The battery is new and passes a conductance test; charging voltage is 14.1 V with loads on.
503 words, about 3 min3Alignment Readings After a Pothole Impact
A 2014 SUV with 140,000 km hit a pothole on the left front. The driver reports a pull to the right, the steering wheel is off-centre to the right, and there is a vibration at 90–100 km/h.
487 words, about 2 min4Intermittent Stall With Crankshaft Sensor Code
A 2016 2.0 L petrol car with 98,000 km stalls intermittently when hot, usually at idle after 20–30 minutes of driving. It restarts after 15–20 minutes and runs normally.
516 words, about 3 min5Two-Post Hoist and Corroded Brake Line Under Time Pressure
A 2013 van weighing 2.9 t is on a 3.2 t two-post hoist for a rear brake inspection. The technician has raised it about 1.6 m.
510 words, about 3 min