KSE Professional Engineer case studies
KSE Professional Engineer · Put your knowledge to work in context.
The KSE Professional Engineer credential is a professional engineering qualification assessed across eight published domains: engineering fundamentals and applied science (15%), design and analysis (20%), project planning and management (15%), codes, standards, and regulatory compliance (15%), health, safety, and environmental protection (10%), quality assurance and testing (10%), professional ethics and practice (10%), and communication, documentation, and records (5%). It suits engineers who already hold a technical foundation and are moving into roles where they sign off on design decisions, coordinate multidisciplinary work, and carry accountability for compliance and safety outcomes. The KSE Professional Engineer case studies are 5 cases and about 4,302 words.
1Re-rating a Two-Phase Separator After a Process Change
A vertical two-phase separator built in 1998 is being debottlenecked. Nameplate data: SA-516 Gr 70 shell, inside diameter 1800 mm, nominal shell thickness 19.05 mm, seamless course with joint efficiency E = 1.0, corrosion allowance 3.0 mm, design 1.6 MPa at 120 C, MDMT -29 C.
866 words, about 4 min2Recovering a Slipping Schedule Without Cutting a Witness Hold Point
Your firm is the owner's engineer on a 24-month, USD 18.6 million expansion. At the end of month 9 the controls report shows PV = USD 7.2 M, EV = USD 6.1 M and AC = USD 6.8 M.
844 words, about 4 min3Stratified Hydrogen Sulfide in a Lift-Station Sump Entry
A contractor is preparing to enter a 3.2 m deep, 1.4 m diameter concrete lift-station sump to replace a corroded guide rail. The entry permit was issued this morning after a single set of readings taken at the top of the opening with a calibrated four-gas meter: oxygen 20.4 percent, LEL 0 percent, H2S 6 ppm, CO 0 ppm.
851 words, about 4 min4Low Cylinder Breaks and a Request to Edit the Test Report
A 120 cubic metre pour of a 28 MPa specified compressive strength reinforced concrete mat was sampled and tested. The 28-day results, where each strength test is the average of two 150 x 300 mm cylinders tested to ASTM C39, are: set 1, 26.4 and 25.8 MPa for a test result of 26.1; set 2, 24.2 and 25.0 MPa for 24.6; set 3, 25.6 and 26.0 MPa for 25.8.
891 words, about 4 min5Sealing a Supplier's Shoring Design Under Commercial Pressure
You are a professional engineer in a consulting firm that earns about 40 percent of its fee from one industrial client. The client's logistics contractor has submitted a proprietary modular shoring system, 34 m tall, for facade work on the client's warehouse.
850 words, about 4 min